NANO, a Simple, integrated device. There are 4 colors on the device: gold, red, green, black. You could change the top cover because it have a separate cap design.

15s of fast preheating time, 300s of enjoyment, allow the consumption of 20 tobacco sticks at a single charge, one-button operation, simple and fun.

Let's see the review from the fans of  the famous heated tobacco Community heat180

UNBOXING

In your Yun Xi Ismod Nano kit you will find; the device, the manual, a warranty card, a USB cable, and cleaning sticks.

Before using your device, it’s best to check what percent charge it has. To do this, click the control button once. The color of the light will indicate what percent charge is remaining. Blue means 100%-60% remaining, yellow is 60%-10%, red is 10%-0%. If the light shows anything other than blue we recommend charging. To do so, just connect the device to a power source via the USB cable. Charging takes approximately 1.5 hours.

HOW TO USE

Now that your device is fully charged, you can being using it. Just follow the instructions below;

1.       Insert HeatStick

2.       Press and hold control button to turn on

3.       Device will vibrate and light flashes while heating

4.       Once the heating has started, set temperature by clicking control button 5 times, then once each time you want to change the temperature level – light color will indicate set temperature

o   Green = low temperature

o   White = medium temperature

o   Purple = high temperature

5.       When heating is complete, device will vibrate and light turns solid

6.       30 seconds before the end of the cycle you will get warning vibration and light will begin flashing

7.       When cycle is over, device will vibrate and light turns off

8.       Remove HeatStick by pressing up on HeatStick Eject button

With Ismod Nano you can get 20 consecutive uses before needing to charge again.

You’ll want to clean your device regularly to maintain good device health. Unfortunately, Ismod Nano does not offer automatic-cleaning, so to clean just remove the cap and use the cleaning sticks to wipe away any grime inside the HeatSticks heating chamber. We recommend doing this at least once per week.

HEATSTICKS OVERVIEW

MANUAL